DIY Smart Garage Opener Kit (Zooz MultiRelay + Zooz Tilt Sensor)

Zooz S2 Z-Wave Plus MultiRelay ZEN16 Terminal View

Zooz S2 Z-Wave Plus MultiRelay ZEN16 Use Cases

Zooz S2 Z-Wave Plus MultiRelay ZEN16 Wiring Diagram

Zooz S2 Z-Wave Plus MultiRelay ZEN16 Back View

Zooz 700 Series Z-Wave Plus Tilt | Shock Sensor ZSE43 Packshot

Zooz 700 Series Z-Wave Plus Tilt | Shock Sensor ZSE43 vertical and horizontal functionality

Zooz 700 Series Z-Wave Plus Tilt | Shock Sensor ZSE43 Accessories

Zooz DIY Smart Garage Opener Kit (MultiRelay ZEN16 VER. 1.0 + Tilt Sensor ZSE43)

$49.95 $56.90

| /

Z-WAVE GARAGE FOR LESS

Make your garage smart with minimal effort and cash. Just attach the tilt sensor to your garage door and connect the ZEN16 to your existing door switch on the wall. You can control up to 3 doors with a single ZEN16 independently (but you'll need to get additional sensors to monitor them). Scroll down to the "Works with" section for dedicated hub instructions.

IN THIS PACKAGE:

ZOOZ S2 MULTIRELAY ZEN16 VER. 1.0 (500 SERIES)

You don't need to touch any wiring at the garage opener. Just take the 2 wires from the door switch and attach them to the R1 terminals on the ZEN16. Connect the switch to the Sw1 terminals with another 2 wires, power the ZEN16 up and you're all set. Please make sure your existing opener doesn't have any smart or electronic features and is controlled by a simple momentary wall switch before buying.

ZOOZ 700 SERIES Z-WAVE PLUS TILT | SHOCK SENSOR

The sensor mounts directly on your garage door to notify you if the gate is open or closed based on its position. It comes with adhesive tape and can be mounted outdoors with a dedicated weatherproof case (sold separately) for flexible installation. Its 700 series Z-Wave chip offers longer range and battery life. Covered under a 5-year warranty.

Find out more about the Zooz Tilt Sensor