Zooz Z-Wave Plus Flood Prevention Kit: Pro (ZAC36 + 2 ZSE42 Sensors)

$169.85 $219.80

| /

MEGA SAVINGS

Get more value on the most dependable DIY Z-Wave flood protection system! With the 700 series technology, you benefit from more wireless range and faster response time on both devices. Remember to verify that your hub supports these products before buying.

  PRO INSTALLATION NOW AVAILABLE!  

Z-Box Smart Flood Prevention Kit Professional Installation

Click the image above to schedule a consultation with an installer for a 100% worry-free set-up!

IN THIS KIT:

1 x ZOOZ Z-WAVE PLUS 700 SERIES TITAN WATER VALVE ACTUATOR ZAC36

This water valve actuator comes with a powerful motor and unique design that allows you to install it in less than a minute without any tools. And it can be mounted outdoors too! Program the Titan to shut water off automatically whenever a leak is detected by any of the connected sensors.
Find out more about the Zooz 700 Series Titan Water Valve Actuator

2 x ZOOZ 800 SERIES Z-WAVE LONG RANGE XS WATER LEAK SENSOR ZSE42 800LR
These extra small water leak sensors from Zooz can be easily placed under furniture for discreet and reliable monitoring. Once water is detected, they'll send a notification to the hub immediately. You can use the report to program an automatic shut-off using your Titan valve actuator.

Next Previous

Customer Reviews

Based on 5 reviews
80%
(4)
20%
(1)
0%
(0)
0%
(0)
0%
(0)
R
Rory Coffey
Flood prevention kit works very well

Easy setup and now controls my main water valve. The only hiccup was with the water sensors and hence the 4 instead of 5 stars. For some reason they added themselves multiple times to my z-wave dongle. Changing to newer batteries solved that issue, though I needed to factory reset the dongle to remove the repeat appearances.

M
Matt
Great Product, Great Service

I was initially planning on installing the Moen Flo smart valve, but after after reading about build quality and reliability issues, I started looking for an alternative. This valve actuator from Zooz fit the bill perfectly. Unlike plumbed-in smart valves, the Titan lets me use a conventional (i.e. higher quality) valve. In my case, I installed the device on a 3/4 inch commercial grade Pex-A ball valve from Uponor. I wasn't sure whether the expansion rings on either side of the valve would interfere with the clips on the Titan, but the spacing wasn't an issue. Installing the valve and integrating it into my Home Assistant setup took less than 5 minutes. Since then, it has worked flawlessly.

Unfortunately, I received different leak sensors than those advertised as coming in the kit (I received the older, non-LR models). TSH customer support promptly offered to exchange the incorrect sensors and shipped a new set of sensors to me within hours of me initially emailing them. 10/10 customer service.

J
James Thomas
Zooz Titan water valve

This valve has saved me Twice in last year. My boiler blow off valve opened and water was dumping on floor I had a Zooz leak detector near furnace and it closed my main water valve saving me big time. Second Time my second floor shower drain broke and water was leaking into the first floor ceiling then it was running down to basement and the same water leak sensor got wet and sent signal to the Titan water valve shit off. Works great its worth the price.

G
George
Very Easy to install

I was looking at a competitor product but was attracted to ZOOZ as i wanted a solution this is managed by a home controller (not dependent on the internet). this was it. took 5-10 mins to install along with 2 wireless sensors. using home assistant. impressive to see how a bit of water triggers the valve to close. impressive!

K
Kevin
Just works

After two issues in two months I asked my plumber to replace a section of PVC pipes with copper so I could install this.

It was really easy to install on my copper pipes just after my water tank. It connected easily to my home assistant with Zooz controller stick.

I successfully tested it by spilling a few drops of water on the wired sensor and it immediately activated and closed the valve.

The two bundled water leak sensors were even easier to connect to home assistant and are now vigilantly sitting in by my boiler and under my dish washer.