Zooz Momentary In-Wall Switch ZAC99 for Z-Wave Dimmer Modules

Accessorize Affordably

PRODUCT HIGHLIGHTS

• 1-button momentary switch (press a single paddle in sequence for on/off and hold for dimming)
• Adds dimming capability to your favorite Z-Wave dimmer module from the wall switch
• Works with these Zooz models: ZEN71 On/Off Switch, ZEN72 Dimmer, ZEN75 Heavy Duty Switch, ZEN32 Scene Controller, and ZEN35 Scene Dimmer.
  
• Cannot be used with the ZEN73, ZEN74, ZEN76 or ZEN77 models in any capacity
• Use it with the Fibaro Dimmer to complete multi-point installations without neutral
• Slim design leaves enough space in the switch box to easily fit a Z-Wave dimmer behind
• Clean look and solid built
• UL listed: meets North American safety standards
• 1-year warranty

NOTE: This is NOT a Z-Wave device. You need a compatible Z-Wave dimmer module for wireless control.

HOW IT WORKS

This Zooz Momentary Switch is the perfect addition to your Z-Wave dimmer module. Its operation is simple but its potential is great: tap it to turn your Z-Wave dimmer on, press and hold it to adjust brightness, tap it again to turn it off. It is not a Z-Wave device by itself, and should be used with a behind-the-switch Z-Wave module for wireless functionality.

Use it to complete a 4-way or other complex multi-point control set-ups with the Fibaro Dimmer to add Z-Wave to circuits with no neutral. Its slim and compact form factor leaves extra space in your switch box making installation worry-free. The simple decora style will complement most interiors.

INSTALLATION

Before proceeding with the installation, turn off the power in the switch box. Make sure you have either 12 or 14 AWG copper wire, since this is the only type of wiring that’s approved for this installation. If needed, strip the wiring of its insulation (exposing 0.75” will be enough). Connect all wires to all screw terminals, including the ground wire. Tighten all the screws, and secure your Z-Wave module and the momentary switch in the box using the mounting screws. Be sure to handle the wires carefully. Install the wall plate, and turn the power back on to test the device.

WORKS WITH

• Aeotec By Aeon Labs Z-Wave Plus Nano Dimmer ZW111 (no neutral needed!)
• Fibaro Z-Wave Plus Dimmer 2 FGD-212 (no neutral needed!)
• Qubino Z-Wave Plus Flush Dimmer ZMNHDD3
• Qubino Z-Wave Plus Flush RGBW Dimmer Module ZMNHWD3

SPECIFICATIONS

• Model Number: ZAC99
• Type: Momentary contact
• Power: 120 VAC, 60 Hz
• Maximum Load: 15A
• Operating Temperature: 32-104° F (0-40° C)
• Installation and Use: Indoor only
• Dimensions: 4” x 1.5” x 1.4”

RESOURCES

Download the Manual for Momentary In-Wall Switch ZAC99 (PDF)