Qubino Z-Wave Plus Flush Shutter DC Module ZMNHOD3 for 12-24V Motors

Smooth Shade Control 

PRODUCT HIGHLIGHTS

• Adds Z-Wave control to 12-24V motor shades, blinds, and shutters
• Automatic calibration and precise positioning
• Works with motors controlled by mechanical and electronic wall switches
• Provides energy use reports for your motorized shades*
• Built-in signal repeater and the latest Z-Wave Plus chip for stronger network
• Super small form factor makes the installation quick and convenient
• Adds to your Z-Wave hub in seconds with the new auto-inclusion feature
• Designed and manufactured in Europe
• 2-year warranty

NOTE: Z-Wave gateway controller required - sold separately. *Your controller needs to support advanced configuration and parameter input to display these features.

GET ACCESSORIES

HOW IT WORKS

Be the master of the sun - while you’re in your smart home at least. The Qubino Flush Shutter DC is the answer to automating your window blinds, shades, rollers, awnings, or curtains with 12-24V DC motors. When connected to your Z-Wave gateway controller, control your blinds wirelessly or with a wall switch.

Check the status of Z-Wave connected blinds on your smart phone or computer; easily open and close them at the push of a button. Monitor the power consumption of your blinds to save on energy bills. Create daily schedules to open and close your blinds automatically based on the position of the sun. Instantly close them as soon as the sun sets to easily maintain your privacy.

Equipped with the latest Z-Wave Plus technology and a signal repeater, the Qubino Flush Shutter DC is a small way to greatly improve your entire smart home.

INSTALLATION

• If you are unfamiliar with the process of installing electrical wiring into a flush mounting box, please contact a licensed and qualified electrician.
• Be sure the power supply is completely disconnected and the fuse disabled.
• Be sure the recommended loads are never exceeded. Failure to do so may result in injury and/or damage to your device.

If including the Flush Shutter DC to your Z-Wave network automatically, first put your Z-Wave gateway controller into inclusion/pairing mode. Then connect the module to the power supply (see your operational manual for details). Within a few seconds you will see the new device on your controller’s device list. 

If including manually, first connect the device to the power supply. Then, put your controller into inclusion/pairing mode. Press the S (service) button for at least 2 seconds. Once successfully included, the Flush Shutter module will appear on your controller’s device list. It will most likely show up as shutter control or motor controller.

WORKS WITH

NOTE: If you don't see your Z-Wave controller on the list above, please contact us before you purchase this product.

SPECIFICATIONS

• Z-Wave Frequency: 908.42 MHz (US)
• Power Supply: 24VDC
• Maximum Load: 2A
• Power Consumption: 0.3W
• Operating Temperature: 14 - 104 F
• Dimensions: 1.6" x 1.4" x 0.6"
• Weight: 1 oz

RESOURCES

Download the Manual for Qubino Z-Wave Plus Flush Shutter DC Module ZMNHOD3 (PDF)