NEW IMPROVED VERSION: updated battery type for longer and better performance + even quicker motion detection in the same large range!
4 different sensors in 1 smart device: motion, light, temperature, and humidity
Customize your sensor with 7 levels of motion sensitivity
Easy-to-follow LED temperature notifications
Security enabled Z-Wave Plus product with AES signal encryption
New and improved 500 chip for enhanced wireless communication
Capable of advanced home automation when linked with other Z-Wave devices
Z-Wave range of 100 feet (line of sight)
Built-in tamper protection
Fast and easy installation
Sleek, subtle design
NOTE: Z-Wave gateway controller required - sold separately. You need a security enabled controller to take full advantage of the product.
Tested to be the quickest Z-Wave motion detector among multisensors for SmartThings, watch video here (start at 38:20 for the ZSE40 review):
HOW IT WORKS
Temperature, humidity, light, and motion - these are some of the cornerstones that make a home comfortable, efficient, and safe. Now imagine having these things controlled by a single device. Brimming with features, the Z-Wave Plus 4-in-1 Sensor is an efficient solution for solid home protection. When linked to your Z-Wave gateway controller, monitor and control your home from your mobile device. Receive notifications when the temperature or humidity changes. Be alerted when motion is detected unexpectedly. This sensor has 7 levels of motion sensitivity, allowing you to customize its settings for your specific needs. The 4-in-1 sensor can even be programmed for advanced home automation when connected to other Z-Wave products - make the temperature decrease when the lights shut off, or link up this sensor with a Z-Wave siren for added smart home security.
Setting up your 4-in-1 sensor is a fast, easy process. Just be sure to connect it to your Z-Wave network before mounting. To include the sensor:
Insert the CR123A battery and bring the device as close to your Z-Wave gateway controller as possible
Switch your Z-Wave controller into inclusion/pairing mode
Press and release the Z-Wave button TWICE quickly with a paperclip
The new 4-in-1 sensor will appear on your controller’s device list
To disconnect it from your Z-Wave network, simply repeat the steps above but with your Z-Wave controller in exclusion/unpairing mode. Next, take the batteries out and put them back in. The LED indicator should flash 3 times, indicating the device has been successfully excluded.
If the LED indicator blinks only once when you re-insert the batteries, please repeat the process above.
To mount the sensor, choose a spot inside your home - at least 7 feet above the ground will yield the best results. With the 2 included screws, attach the mounting bracket to any flat surface - on your basement ceiling, in the corner of your entry hall, wherever you’d like. Once the bracket is secure, slide the 4-in-1 sensor into position and tilt the body in the direction of your choice.
Or use the supplied adhesive tape to quickly mount the sensor on any clean surface indoors.
Home Assistant (works best with device specific code, install here)