Remembers and restores its state after power outage
Comes with auto-inclusion mode for the quickest set-up possible
Schedule the switch to automatically turn on or off after a fixed period of time with the built-in timer*
Made in Europe: supreme quality and latest Z-Wave Plus technology
NOTE: Z-Wave gateway controller required - sold separately. *Your controller needs to support advanced configuration and parameter input to display these features.
HOW IT WORKS
The Qubino Flush 1 Relay gives your existing lamps and small appliances the power of Z-Wave. This single module lets you remotely control the connected device without affecting full manual control. When paired with your Z-Wave gateway controller, check the on/off status of a light on your smart phone or computer, and turn it off if need be.
Save on your utility bills by always being in the know: this module even monitors the power consumption of the connected device, in live mode and over time. Connect the module with other Z-Wave devices for an even smarter home: turn on the welcome lights when you open your front door in the evening. Turn off the basement lights as soon as you head back up the stairs.
This single relay module is equipped with over a dozen advanced parameters for further customization. And not only is it outfitted with Z-Wave Plus technology for better range and connectivity, it also acts as a Z-Wave signal repeater to improve your entire network's performance.
Completely disconnect the power supply by disabling your circuit breaker or main fuse. Ensure no voltage remains in the electrical system.
Do not exceed the recommended loads — doing so may result in injury and/or damage to the device.
Follow the diagrams in your instructional manual exactly to ensure proper installation. If you are unfamiliar with electrical wiring, please contact a licensed electrician to install your single relay module.
To auto-include the module into your Z-Wave network, FIRST put your Z-Wave gateway controller into inclusion/pairing mode. Then connect the module to the power supply. The device will auto-include within 5 seconds after the power supply has been activated.
You're also able to include the device manually. Connect it to the power supply. Put your controller into inclusion mode. Toggle the wall switch connected to the I1 terminal 3 times quickly. Once successfully included, the new module will appear on your controller’s device list.