Z-WAVE GARAGE FOR LESS
Make your garage smart with minimal effort and cash. Just attach the tilt sensor to your garage door and connect the ZEN16 to your existing door switch on the wall. You can control up to 3 doors with a single ZEN16 independently (but you'll need to get additional sensors to monitor them). Scroll down to the "Works with" section for dedicated hub instructions.
IN THIS PACKAGE:
ZOOZ S2 MULTIRELAY ZEN16
You don't need to touch any wiring at the garage opener. Just take the 2 wires from the door switch and attach them to the R1 terminals on the ZEN16. Connect the switch to the Sw1 terminals with another 2 wires, power the ZEN16 up and you're all set. Please make sure your existing opener doesn't have any smart or electronic features and is controlled by a simple momentary wall switch before buying.
Find out more about the Zooz MultiRelay
ECOLINK Z-WAVE PLUS TILT SENSOR
The sensor mounts directly on your garage door to notify you if the gate is open or closed based on its position. It comes with adhesive tape and mounting bracket for flexible installation. Its Z-Wave Plus chip offers longer range and a battery life up to 5 years.
NOTE: If you don't see your Z-Wave controller on the list above, please contact us before you purchase this kit.
GET POWER SUPPLY