DIY Smart Garage Opener Kit (Zooz MultiRelay + Ecolink Tilt Sensor)

Z-WAVE GARAGE FOR LESS

Make your garage smart with minimal effort and cash. Just attach the tilt sensor to your garage door and connect the ZEN16 to your existing door switch on the wall. You can control up to 3 doors with a single ZEN16 independently (but you'll need to get additional sensors to monitor them). Scroll down to the "Works with" section for dedicated hub instructions.

IN THIS PACKAGE:

ZOOZ S2 MULTIRELAY ZEN16

You don't need to touch any wiring at the garage opener. Just take the 2 wires from the door switch and attach them to the R1 terminals on the ZEN16. Connect the switch to the Sw1 terminals with another 2 wires, power the ZEN16 up and you're all set. Please make sure your existing opener doesn't have any smart or electronic features and is controlled by a simple momentary wall switch before buying. 
Find out more about the Zooz MultiRelay

ECOLINK Z-WAVE PLUS TILT SENSOR

WORKS WITH

• Fibaro Home Center 2 best with this set-up
• Fibaro Home Center Lite (click here for set-up instructions)
• Home Assistant with this programming set-up
• Hubitat works best with custom SmartApp
• ISY with these settings
• openHAB (2.5.1 or higher) best with this set-up
• SmartThings Hub works best with dedicated SmartApp
  
• VeraEdge Z-Wave Gateway Controller with this App set-up
• VeraPlus Z-Wave Plus Advanced Home Controller with this App set-up
• VeraSecure Z-Wave Plus Advanced Home Security Controller with this App set-up

NOTE: If you don't see your Z-Wave controller on the list above, please contact us before you purchase this kit.

GET POWER SUPPLY

DC:OR USB: