Z-WAVE+ GARAGE MONITOR
NEW Z-Wave Plus version of the most popular garage sensor
- Reports status change of your garage gate or any other tilting surface remotely (once included to your Z-Wave hub)
- Get notified if a garage door is still open once you left home or close it automatically with the Qubino Dry Contact relay connected to your wall switch
- Built-in tamper switch for additional security
- Quick and easy to install (mount it with screws or tape, both included)
- 5-year battery life
- 3-year Ecolink warranty
NOTE: Z-Wave gateway controller required - sold separately.
HOW IT WORKS
The Ecolink Z-Wave Plus Tilt Sensor is not just a reliable security device, it’s peace of mind. Never leave your house again wondering if you’ve left the garage door open. This small sensor sits directly on your garage door and sends you helpful open/close alerts so that you never come home to a surprise. Just add the sensor to your Z-Wave hub for remote monitoring of your garage door via your smart phone, tablet, or computer. To make your set up more advanced, pair it with this dry contact module to get easy remote control of your garage door.
This new and improved version features Z-Wave Plus, a step up from the older model. Z-Wave Plus translates to longer range (goodbye, garage connectivity issues!), way more bandwidth, and a longer-lasting battery life.
Before mounting the device, you’ll need to include it to your Z-Wave network. Put your Z-Wave hub into inclusion/pairing mode (refer to your hub’s manual for specific inclusion instructions, as each brand is different). Then, simply insert the battery to activate inclusion mode in the device. If inclusion was successful, the LED will turn red for 10 seconds and then turn off. If you see the LED flashing, inclusion was unsuccessful and you should repeat the steps above.
Verify that your desired installation location is within solid range of your Z-Wave hub; be sure to test the device from that location to establish good communication. You can mount the sensor using either the included screws and mounting bracket of the adhesive tape – determine which method is best for your garage door.
Make sure to position the sensor at the top section of your multi-panel garage door AND have the arrow on the left side of the device pointing UP – this is important for the device’s functionality. Before mounting, make sure the target surface is clean and dry. Whether you’re using screws or adhesive, follow the manual instructions exactly.
If you experience any problems at all during the set-up process, feel free to contact our fast and friendly tech support for help.
NOTE: If you don't see your Z-Wave controller on the list above, please contact us before you purchase this product.
- Z-Wave Frequency: 908.42 MHz (US)
- Power: 3V Lithium CR123A battery (included)
- Wireless Range: up to 100 feet
- Operating Temperature: 32°-120°F (0°-49°C)
- Installation: Indoor
- Dimensions: 4 x 1.9 x 0.8 inches
- Weight: 4 oz
Download the manual for Ecolink Z-Wave Plus Garage Door Z-Wave Tilt Sensor TILTZWAVE2.5-ECO here (PDF)