NEW IMPROVED VERSION: updated battery type for longer and better performance + even quicker motion detection in the same large range!
4 different sensors in 1 smart device: motion, light, temperature, and humidity
Customize your sensor with 7 levels of motion sensitivity
Easy-to-follow LED temperature notifications
Security enabled Z-Wave Plus product with AES signal encryption
New and improved 500 chip for enhanced wireless communication
Capable of advanced home automation when linked with other Z-Wave devices
Z-Wave range of 100 feet (line of sight)
Built-in tamper protection
Fast and easy installation
Sleek, subtle design
NOTE: Z-Wave gateway controller required - sold separately. You need a security enabled controller to take full advantage of the product.
Tested to be the quickest Z-Wave motion detector among multisensors for SmartThings, watch video here (start at 38:20 for the ZSE40 review):
HOW IT WORKS
Temperature, humidity, light, and motion - these are some of the cornerstones that make a home comfortable, efficient, and safe. Now imagine having these things controlled by a single device. Brimming with features, the Z-Wave Plus 4-in-1 Sensor is an efficient solution for solid home protection. When linked to your Z-Wave gateway controller, monitor and control your home from your mobile device. Receive notifications when the temperature or humidity changes. Be alerted when motion is detected unexpectedly. This sensor has 7 levels of motion sensitivity, allowing you to customize its settings for your specific needs. The 4-in-1 sensor can even be programmed for advanced home automation when connected to other Z-Wave products - make the temperature decrease when the lights shut off, or link up this sensor with a Z-Wave siren for added smart home security.
Setting up your 4-in-1 sensor is a fast, easy process. Just be sure to connect it to your Z-Wave network before mounting. To include the sensor:
Insert the CR123A battery and bring the device as close to your Z-Wave gateway controller as possible
Switch your Z-Wave controller into inclusion/pairing mode
Press and release the Z-Wave button TWICE quickly with a paperclip
The new 4-in-1 sensor will appear on your controller’s device list
To disconnect it from your Z-Wave network, simply repeat the steps above but with your Z-Wave controller in exclusion/unpairing mode. Next, take the batteries out and put them back in. The LED indicator should flash 3 times, indicating the device has been successfully excluded.
If the LED indicator blinks only once when you re-insert the batteries, please repeat the process above.
To mount the sensor, choose a spot inside your home - at least 7 feet above the ground will yield the best results. With the 2 included screws, attach the mounting bracket to any flat surface - on your basement ceiling, in the corner of your entry hall, wherever you’d like. Once the bracket is secure, slide the 4-in-1 sensor into position and tilt the body in the direction of your choice.
Or use the supplied adhesive tape to quickly mount the sensor on any clean surface indoors.